EL SHEETS

The proper way to cut raw (not laminated) EL sheets.
This is the back of the EL sheet. It can be cut in any shape providing a portion of the of the Bus (thick, double line running around the edge) is kept. The bus is required to distribute power to the EL sheet.

Powering up EL sheets to make EL Lamps. The Flat EL lamp hookup is very simple and can be broken down into six easy steps.
1 -cut the EL to desired size
2 -attach the Bus Bar
3 -laminate the EL
4 -use an Exacto knife to expose the copper Bus Bar
5 -solder the wires to the Copper Bus Bar
6 -Cover the connection with an adhesive vinyl tape, hot melt glue or silicone.

Detailed instructions and tips for hookup are available upon request. Please refer to pictureA - Inner Bus (powers back of EL sheet).B - Outer Bus (powers front of EL sheet). 1 - A small, cut section of 22" Bus Bar (top view). 2-3 - Bottom of Bus Bar with the wax paper removed, revealing adhesive side and the copper strip (used to make a solder connection). 4-5-6 - Different stages of hookup.

Thank you for visiting your #1 source for Flexible Electroluminescent Lighting Products.

"Free technical support to everyone, even if you did not buy our products" We will respond to all e-mails and inquiries with 24 hours.

terms and conditions | contact | instructions

Dealers please call (888) 457-0117 for wholesale
pricing & custom packaging!

Please call us at:
1 (888) 457-0117 (Toll-Free, USA only)
1 (508) 279-4244 (International)

Copyright © 1998-2002 Being Seen Technologies, Inc. All Rights Reserved. Designated FlatNeon™, FlexibleNeon™, NeonFX™, EL Sabers™, NeonCable™, NeonWire™ PC Neon CaseMods™, trademarks are the property of Being Seen Technologies, Inc.

designed by:
www.phatgecko.com